forum.heli-x.info

I am using full version.
i looked for advice on learning with a sim.
read its good to learn to hover with a slow piro, 1 rotation per minute.
if i use the rudder trim in config the heli starts tail in,turns to side on then stops.
i found in the training section a option on rotation,chose i per minute but again it stops side on.
i chose heli-x the control rudder and it also stops side on.
i have looked to see if there is a camera view or angle that might need changing but can not see one thats relevent.
any ideas?

Why don't you just trim in your radio?

Hi

I just tried this setting with the Specter V2 and it rotates very slowly, as expected. I stopped after 360 degrees
It might be, that by your input on aileron and elevator, you influence the rotations ...

I have the same problem, if you activate rudder in manual mode, it doesn't manage to make the complete turn in 1min.

Are you using V11? Please also try the other speeds.